From: Hans-Jürgen (e9625788@student.tuwien.ac.at)
Date: Sun Apr 09 2000 - 18:16:13 CEST
> > On Wed, Apr 05, 2000 at 08:34:13PM +0200, Hans-Jürgen nicely wrote:
> > > Does anyone use Mulinux as Gateway and can tell me how two configure
> > > multiple ethernet cards?
> > > I have two ne2000 clones and later i will have one ne2000 and one 3Com
> card.
> > >
> > > What i tried:
> > > use setup -f eth and choosed ne as module and put io=240,300 irq=3,10
as
> > > parameters.
> > > the two cards were detected but i could not configure the second card
> with
> > > ifconfig and route cause the device eth1 was not found.
> > >
> >
> >
> > Configure card-1 with standard "setup network", and card-2 with
> > "setup local". A true support for multiple NIC card are under
> > development ( a TODO)
> >
Ok i tried that but i get the message: modul not found if i try to load a
modul with setup -m ne.o or
setup -m /tmp/modules/preferred/net/ne.o. How do i load a module with in
rc.local and how can i handle the parameters to the modul?
---------------------------------------------------------------------
To unsubscribe, e-mail: mulinux-unsubscribe@sunsite.auc.dk
For additional commands, e-mail: mulinux-help@sunsite.auc.dk
---------------------------------------------------------------------
To unsubscribe, e-mail: mulinux-unsubscribe@sunsite.auc.dk
For additional commands, e-mail: mulinux-help@sunsite.auc.dk
This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:13 CET