From: Karl-Heinz Zimmer (khz@stardivision.de)
Date: Tue Jan 11 2000 - 09:15:15 CET
On 11.01.00, 02:11:37, Robert Heezeman wrote:
> Where is lilo.conf I am running EXT2 from HDD
Unfortunately there is *no* lilo in muLinux at all. :-(
You could try the following (if you like to):
a) Download the 4 little files to be found on
http://www.snafu.de/~khz/download/mulinux
b) Take a new, formatted floppy disk and insert
it into the drive without(!!) mounting it.
c) Copy the muLoadS0.raw (that's a slightly modified
boot loader of my old debian security disk) to the
very first sector of the floppy disk:
dd if=/muLoadS0.raw of=/dev/fd0 count=1
d) Now(!!) mount the floppy.
e) Copy the three other files to the floppy.
cp ldlinux.sys /mnt/floppy
cp message.txt /mnt/floppy
cp syslinux.cfg /mnt/floppy
f) If you need or must just modify the syslinux.cfg
to fit your needs.
It normally contains this:
1. DISPLAY message.txt
2. TIMEOUT 40
3. PROMPT 1
4. DEFAULT mulinuz
5. APPEND root=/dev/hda1 ro
^^^^^^^^^
The '/dev/hda1' in line 5 reflects the fact that I
cloned to the first partition of the first hard disk
(at home using an ugly IDE bus instead of SCSI).
Please modify it as needed.
g) Unmount the floppy and reboot while leaving the floppy
in the drive to use it as boot disk.
You will notice that this floppy boots extremely fast and
goes to your muLinux (that you cloned to the hard disk before)
without loosing any time.
This solution is *not* very smart (cause you still need a floppy)
but it is the most simple one I could imagine and: it works! :)
Have a nice day,
Karl-Heinz
-- K.-H. Zimmer * Hamburg * Germany --------------------------------------------------------------------- To unsubscribe, e-mail: mulinux-unsubscribe@sunsite.auc.dk For additional commands, e-mail: mulinux-help@sunsite.auc.dk
This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:13 CET