From: David LeBlanc (dleblanc@uswest.net)
Date: Thu Dec 09 1999 - 20:42:48 CET
> -----Original Message-----
> From: Michele Andreoli [mailto:m.andreoli@tin.it]
> Sent: Thursday, December 09, 1999 10:58 AM
> To: mulinux@sunsite.auc.dk
> Subject: Re: [mu setuo findp] Problems with networking and X11 - HELP
> PLEASE!
>
>
> On Wed, Dec 08, 1999 at 02:15:57PM -0800, David LeBlanc nicely wrote:
> > Hi;
> >
> > I have deleted c:\linux and done a clean install of 7r4b again
> to c:\linux
> > (umsdos).
> >
> > Trying to setup the network (abreviated)
> > "setup -f network"
> > pcmcia (1) yes
> > (interface) eth0
> > (DHCP) yes
> > Intel PCIC probe detects Ricoh RL5C475 PCI-to-Cardbus at bus 0 slot 3, 1
> > socket.
> > cardmgr finds "Linksys Ethernet" on socket 0.
> > cardmgr [1003] executing"insmod /lib/modules/2.0.36/pcmcia/pcnet_cs.o"
> > cardmgr[1003] ethdev_init undefined
> > cardmgr[1003] NS58390_init undefined
> > cardmgr[1003] ei_interrupt undefined
> > cardmgr[1003] ei_open undefined
> > cardmgr[1003] ei_debug undefined
> > cardmgr[1003] Loading failed! The module symbols (from
> linux-2.0.36) don't
> > match your linux-2.0.36.
> > cardmgr[1003] insmod exited with status 2
>
>
> Some pcmcia modules are missing or unsupported. This is pcmcia-3.0.9, very
> recent. Please, what modules support your Ricoh.
>
I do not know what you mean by "what modules support your Ricoh". ???
> >
> > After this, of course, modprobe and DHCP client both failed.
> >
> > With X11, it did auto-configure under 7r3b, but it will not
> under 7r4b. It
> > returns that it cannot find a mode for 640x480 and so the
> server does not
> > start. Any ideas of what is wrong?
> >
>
> Following a suggestion to someone (on the list?), I changed very time ago
> some mode definition. The only solution is to fetch the old XF86Config
> for 6r4 (or earlier) and restore it. Sorry.
>
>
How can I fetch the XF86Config from 6r4 without fetching and installing all
of 6r4?
> > Dave LeBlanc
> >
> > P.S. HOW do you do get ">&" (stderror) redirection with this
> shell?? I have
> > been unable to get it to work.
> >
> >
>
> >& Do not work under ash. Redirect in thy way:
>
>
> command 1>file 2>&1
>
I will give it a try - thanks.
> Michele
>
>
> --
David LeBlanc
---------------------------------------------------------------------
To unsubscribe, e-mail: mulinux-unsubscribe@sunsite.auc.dk
For additional commands, e-mail: mulinux-help@sunsite.auc.dk
This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:12 CET